Unable to use Ghost to deploy images DS 7.1

Hi there

We are and have been using RapiDeploy successfully for quite some time now, but are looking at upgrading to DS7.5, and have been advised the RapiDeploy is no longer supported in 7.5 (although it may still be there?) So we are attempting to move to using Ghost.

This is where the problems begin. I have created a new "Deploy Image" using the previously captured ghost image (using Altiris)

When I boot a computer into WinPE and run this task, the computer gets the task, Ghost opens, then just sits there with the about screen open, and goes no further. As per attached screen shot (capture.png)

I have also attached a sanitized version of a "ClientImageDeploy.log" from the last test client.

Thanks