I do not need a solution (just sharing information)
Hi there, whilst at work today I've been recreating one of our MSI's from Wise into Install Shield 2013 through Visual Studio 2013 and I've been trying to figure out if you could set conditions on dialogs, like you can in Wise, I think the table is WiseDlgSequence.
I couldn't quite figure out if it could be done or not so just thought I'd put a quick post up here and ask if anyone knew or had any experience with it.
I know this isn't specifically a Wise question but it might be general to MSI's or just something you can only do in Wise? not sure.
It's basically to help navigate through dialogs from setting various features levels, the only way I could see was to set different events on the Next button (NewDialog event and a condition, which is fine) but there may become a lot and it gets a little messy when doing the same with the Back buttons to.
Just wondered if anyone had any experience or thoughts on it really..